36 Intel Blade Server Fibre Channel Switch Module SBCEFCSW / FC Expansion Card SBFCM Guide
system
Prompts you, line-by-line, to change blade server configuration settings. Table 12 describes the
system configuration fields. For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Notes
The two components of security are user authentication and fabric security. The user must be authenticated
before gaining access to a switch. If an invalid account name/password combination is entered, that user can
not access the switch, and thus cannot gain access to the fabric. If security is enabled (True) and a valid
account name/password combination is entered, that user can access the switch but can not execute any
command that exceeds their authority (privileges) level. If security is disabled (False) and a valid account
name/password combination is entered, that user has access to all switches in the fabric and can execute all
commands (both user and admin), regardless of their authority (privileges) level.
Examples
The following is an example of the Set Setup SNMP command.
FCSM: user1> admin start
FCSM (admin) : user1> set setup snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency, alert, critical, error, warning, notify, info, debug, mark
Contact (string, max=32 chars) [<sysContact undefined> ]
Location (string, max=32 chars) [<sysLocation undefined>]
Trap1Address (dot-notated IP Address) [10.0.0.1 ]
Table 12. System configuration settings
Entry Description
Eth0NetworkAddress Ethernet Internet protocol (IP) address
Eth0NetworkMask Ethernet subnet mask address for the Ethernet port.
Eth0GatewayIPAddress Ethernet IP address gateway
Eth0NetworkDiscovery Ethernet boot method (1 - Static).
Note: BootP, DHCP, and RARP do not apply
AdminTimeout Specifies the amount of time in minutes the switch waits before terminating an
idle Admin session. Zero (0) disables the time out threshold. The default is 30;
the maximum is 1440.
Security Enabled Enables or disables the enforcement of account names and passwords.
Remote Log Enabled Whether remote logging is enabled or disabled. If enabled, log information is
saved to a remote host that supports the systole protocol.
RemoteLogHost IP Address The IP address of the host that will receive the remote log information if
remote logging is enabled.