Filter
Top Products
138 Intel Blade Swerver Switch Module SBCEFCSW / FC Expansion Card SBFCM: HMM and Troubleshooting Guide
Raw NOVRAM data
This option displays the Expansion Card NVRAM contents in hexadecimal format. This is a troubleshooting
tool; you cannot modify the data.
Advanced Adapter Settings
Use this option to view and set advanced adapter settings. The default settings for the Expansion Card are
listed in Table <$elemparanumonly138 and are described in this section.
Execution throttle: This setting specifies the maximum number of commands that can run on any one port.
When a port reaches its execution throttle, Fast!UTIL does not run any new commands until the current
command is completed. The valid options for this setting are 1 through 256. The default (optimum) is 256.
>4GByte addressing: Enable this setting when the blade server has more than 4 GB of memory available. The
default is Disabled.
LUNs per target: This setting specifies the number of logical unit numbers (LUNs) per device. Multiple LUN
support is typically for redundant array of independent disks (RAID) enclosures that use LUNs to map drives.
The default is 0.
Enable LIP reset: This setting determines the type of loop initialization process (LIP) reset that is used when
the operating system initiates a bus reset routine. When this option is set to Ye s, the device driver initiates a
global LIP reset to clear the target device reservations. When this option is set to No, the device driver initiates
a global LIP reset with full login. The default is No.
Enable LIP full logon: This setting instructs the application specific integrated circuit (ASIC) chip to log in to
all ports after any LIP. The default is Yes .
Enable target reset: This setting enables the device drivers to issue a Target Reset command to all devices on
the loop when a SCSI Bus Reset command is issued. The default is Yes.
Login retry count: This setting specifies the number of times the software tries to log in to a device. The
default is 30 retries.
Port down retry count: This setting specifies the number of times the software retries a command to a port
that is returning port-down status. The default is 30.
IOCB allocation: This setting specifies the maximum number of buffers from the firmware buffer pool that
are allocated to any one port. The default setting is 256.
Table 41. Advanced Adapter Settings
Setting Options Default
Execution throttle 1-256 256
>4GByte addressing Enabled or Disabled Disabled
LUNs per target 0, 8, 16, 32, 64, 128, 256 0
Enable LIP reset Yes or No No
Enable LIP full login Yes or No Yes
Enable target reset Yes or No Yes
Login retry count 0-255 30
Port down retry count 0-255 30
IOCB allocation 1-512 buffers 256 buffers
Extended error logging Enabled or Disabled Disabled