Filter
Top Products
29
zoning
Initiates an editing session in which to change switch zoning attributes. Each parameter is displayed,
one line at a time, and you are prompted for a value. For each parameter, enter a new value or press
the Enter key to accept the current value shown in brackets.
Examples
The following is an example of the Set Config Port command.
FCSM: user1> admin start
FCSM (admin) : user1> config edit
FCSM (admin-config) : user1> set config port 0
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number: 0
------------------------
AdminState (1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online ]
LinkSpeed (1=1Gb/s, 2=2Gb/s, 3=Auto) [Auto ]
PortType (TL / GL / G / F / FL / Donor) [GL ]
TLPortMode (1=TLTargetMode, 2=TLInitiatorMode) [TLTargetMode]
ISLSecurity (Any / Ours / None) [Any ]
SymPortName (string, max=32 chars) [Port0 ]
ALFairness (True / False) [False ]
ARB_FF (True / False) [False ]
InteropCredit (decimal value, 0-255) [0 ]
ExtCredit (dec value, increments of 11, non-loop only) [0 ]
FANEnable (True / False) [True ]
LCFEnable (True / False) [False ]
MFSEnable (True / False) [True ]
MFS_TOV (decimal value, 10-20480 msec) [10 ]
MSEnable (True / False) [True ]
NoClose (True / False) [False ]
IOStreamGuard (Enable / Disable) [Disabled ]
VIEnable (True / False) [False ]
CheckAlps (True / False) [False ]
Table 10. Set Config zoning parameters
Parameter Description
AutoSave Determines whether zoning changes will be saved to flash (nonvolatile) memory (On)
or to RAM (volatile) (Off). The default is On.
Default Determines communication among ports/devices in the absence of an active zone set.
“All” enables all ports/devices to communicate with one another. “None” prohibits
communication among ports/devices.