Filter
Top Products
97
Additional Information
CD player section
System Compact disc and digital audio
system
Laser Semiconductor laser
(λ=780nm)
Emission duration: continuous
Laser output Max. 44.6 µW*
*This output is the value measured
at a distance of 200 mm from the
objective lens surface on the
Optical Pick-up Block with 7 mm
aperture.
Wavelength 780 – 790 nm
Frequency response 2 Hz – 20 kHz (±0.5 dB)
Signal-to-noise ratio More than 90 dB
Dynamic range More than 90 dB
MD deck section
System MiniDisc digital audio system
Laser Semiconductor laser (λ=780 nm)
Emission duration: continuous
Laser output Max. 44.6 µW*
*This output is the value measured
at a distance of 200 mm from the
objective lens surface on the
Optical Pick-up Block with a
7 mm aperture.
Sampling frequency 44.1 kHz
Frequency response 20 - 20,000 Hz
OPTICAL IN (North American model only)
(Square optical connector jacks, rear panel)
Wavelength 700 nm
Tape player section
Recording system 4-track 2-channel stereo
Frequency response 40 – 13,000 Hz (±3 dB),
(DOLBY NR OFF) using Sony TYPE I cassette
40 – 14,000 Hz (±3 dB),
using Sony TYPE II cassette
Wow and flutter ±0.15 % W.Peak (IEC)
0.1 % W.RMS (NAB)
±0.2 % W.Peak (DIN)
Specifications
Amplifier section
AUDIO POWER SPECIFICATIONS:
(U.S.A. model only)
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
with 8 ohm loads both channels driven, from 120–
10,000 Hz; rates 80 watts per channel minimum
RMS power, with no more than 10 % total
harmonic distortion from
250 milliwatts to rated output.
Total harmonics distortion Less than 0.07 %
(8 ohms at 1 kHz, 50 W)
European model:
DIN power output (rated) 60 + 60 watts
(8 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
80 + 80 watts
(8 ohms at 1 kHz,
10 % THD)
Music power output (reference)
140 + 140 watts
(8 ohms at 1 kHz,
10 % THD)
Other models:
The following measured at 120/220/240 V AC, 50/60 Hz
DIN power output (rated) 115 + 115 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
150 + 150 watts
(6 ohms at 1 kHz,
10 % THD)
Inputs
VIDEO (AUDIO) IN: voltage 250 mV,
(phono jacks) impedance 47 kilohms
MIC: sensitivity 1 mV,
(mini jack) impedance 10 kilohms
(Asian model only)
Outputs
PHONES: accepts headphones of
(stereo mini jack) 8 ohms or more
FRONT SPEAKER:
U.S.A. and European models:
accepts impedance of 8 to 16 ohms
Other models: accepts impedance of 6 to 16 ohms
SUPER WOOFER: Voltage 1 V, impedance 1 kilohms
continued