Filter
Top Products
14
?/1
(Power)
2
1
1
3 When “PUSH ENTER!” flashes, press
PUSH ENTER.
Recording starts. During high speed
recording, you cannot listen to the playback
sound. When the recording is completed, the
CD player and the MD deck stop
automatically.
To stop recording
Press x.
If “Retry” flashes in the display
after you press PUSH ENTER in
step 3
A reading failure has occurred, and the MD deck
is trying to read the data again.
• If the retry was successful, the MD deck
continues with CD-MD High-Speed Synchro
Recording.
• If the condition of the inserted CD or the MD is
poor, and retry fails, CD-MD High-Speed
Synchro Recording is disabled. In this case,
“x1” flashes in the display and the MD deck
automatically starts recording in normal
CD-MD Synchro Recording. Note that
monitoring of the recorded signal is not
possible when this occurs.
About recording speed
Recording speed varies with the recording mode
(see page 40).
Tip
When recoding a TEXT-CD, the CD TEXT
information (except for the disc title) is automatically
recorded (see page 50).
Recording a CD on an
MD with High Speed
–– CD-MD High-Speed Synchro
Recording
You can make a digital recording of a CD on an
MD at twice the speed of normal CD-MD Synchro
Recording.
1 Insert a CD you want to record and a
recordable MD.
Insert the MD until the deck pulls it in.
2 Press HIGH SPEED CD-MD SYNC.
The MD deck stands by for recording and
“x2” appears in the display.
x
3