Filter
Top Products
47
Editing an MD
Editing an MD
Before you start editing
You can edit the recorded tracks on an MD. By
using the editing functions, you can create a new
sequence to the recorded MD.
Editing functions
• Name – Labelling MDs
Use this function to label discs and tracks. You
can use upper case, lower case, numbers and
symbols for the titles.
• Erase – Erasing recordings
Use this function to erase a single track, all the
tracks, or a portion within a track.
• Move – Changing the order of
tracks
Use this function to change the track
numbering.
• Divide – Adding track numbers
Use this function to add track numbers. This
lets you locate your favourite phrases quickly.
• Combine – Combining recorded
tracks
By using this function, the blank space between
two tracks is erased and those two tracks are
combined to form one track. You can combine
tracks which are not numerically consecutive,
i.e. the track 1 and track 4, etc.
• Undo – Cancelling the last edit
Use this function to cancel the last performed
edit and restore the contents of the MD to the
condition before the edit.
Before editing
To edit the MD, the MD deck requires the
following conditions:
• The MD is recordable.
• The MD deck is in the Continuous mode.
Before editing, check the conditions by following
the procedure below.
1 Check the tab of the MD to be edited.
If the MD is record protected, “C11” and
“Protected” appear in the display alternately
and the MD cannot be edited.
If the MD is protected against erasure, slide
the tab to close the slot.
2 Press FUNCTION repeatedly until
“MD” appears in the display.
3 Set the “Play Mode Set Up ?” to
“Continue”.
You can edit the MD only in Continuous
mode. You cannot edit the MD in Shuffle or
Program mode.
After editing
, Press A to remove the MD or press
?/1 to turn off the system power.
“TOC” starts lighting or flashing. The MD
recording is completed only after the
recording information is entered to the MD.
Note
The MD editing is completed only after all the editing
information is entered to the TOC at which point the
TOC stops flashing and goes out. Be careful not to
disconnect the power cord or move the deck before
this point. Before disconnecting the power cord, do
the following:
– Remove the MD.
– Press ?/1 to turn off the system.