Filter
Top Products
62
10 Press PUSH ENTER.
The deck starts recording over the existing
track. “S.F Edit: **%” appears while the
track is being recorded. An amount of time
that is roughly equal to or longer than the
playback time of the track is required when
recording over the track. When the recording
finishes, “Complete !” appears in the display
for a few seconds.
To cancel the operation
Press MODE SELECT during step 1 through 9. If
you press PUSH ENTER in step 10 and start
recording, you cannot interrupt the operation.
To cancel the menu operation
Press MODE SELECT.
Notes
• You cannot change the recording level of a track
recorded in LP2 or LP4 mode.
• Do not disconnect the power cord or move the
system while recording is in progress. This may
damage the recording data, preventing recording
from being performed properly.
• Do not use an MD that is damaged or dirty, this
may prevent data from being recorded properly.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it is returned to the original level.
• You cannot return to the original condition after
changing the recording level.
Fade-in and Fade-out
Recording
1 Press FUNCTION repeatedly until
“MD” appears in the display.
2 Press MODE SELECT repeatedly to
select “Set Up Mode”, then press PUSH
ENTER.
3 Move the multi stick toward b or B
repeatedly to select “MD Set Up ?”,
then press PUSH ENTER.
4 Move the multi stick toward b or B
repeatedly to select “MD Edit ?”, then
press PUSH ENTER.
5 Move the multi stick toward b or B
repeatedly to select “S.F Edit ?”, then
press PUSH ENTER.
6 Move the multi stick toward b or B
repeatedly to select “Fade In ?” or
“Fade Out ?”, then press PUSH
ENTER.
7 Move the multi stick toward b or B
repeatedly to select the track number
you want to change the recording level
of, then press PUSH ENTER.
“Time 5.0s” appears in the display.
8 While monitoring the sound, move the
multi stick toward b or B repeatedly to
change the Fade-in, or Fade-out
recording time.
The system plays the portion that will be
recorded over using the Fade-in or Fade-out
Recording. You can set the time at any value
between 1.0 second and 15.0 seconds in
0.1-second increments.You cannot set the
time longer than the track.
Changing the recording level
after recording (continued)