Filter
Top Products
44
x
1 While in recording pause, press MODE
SELECT repeatedly to select “Set Up
Mode”, then press PUSH ENTER.
2 Move the multi stick toward b or B
repeatedly to select “MD Set Up ?”,
then press PUSH ENTER.
3 Move the multi stick toward b or B
repeatedly to select “MD Edit ?”, then
press PUSH ENTER.
4 Move the multi stick toward b or B
repeatedly to select “REC Setup ?”,
then press PUSH ENTER.
5 Move the multi stick toward b or B
repeatedly to select “T.Mark LSync”,
then press PUSH ENTER.
6 Move the multi stick toward b or B
repeatedly to select “LSync”, then press
PUSH ENTER.
“L-SYNC” lights.
7 Press MD NX (or PUSH ENTER
when using synchro recording) to start
recording.
To stop recording
Press x.
To cancel the menu operation
Press MODE SELECT.
Marking track numbers
The track numbers can be marked as follows:
• Mark the track numbers automatically.
When you record from this system’s CD
(digital recording) or during level-synchro
recording, the track numbers are automatically
marked.
• At any point while recording.
You can mark the track numbers while
recording any sources.
• After recording.
You can use the Divide function (see page 56).
Marking track numbers
automatically while recording
— Level-Synchro Recording
The Level-Synchro Recording is factory set to on
and the track numbers are automatically marked.
If “L-SYNC” is not displayed during recording,
turn it on as follows. Track numbers are
automatically marked when the input signal is
under a certain level for more than two seconds
and then exceeds the previous level.
?/1
(Power)
Multi stick
PUSH ENTER
1
7