Filter
Top Products
36
To clear a desired step from the
program
1 Press FUNCTION repeatedly until “MD”
appears in the display.
2 While in stop mode, press MODE SELECT
repeatedly to select “Set Up Mode” then press
PUSH ENTER.
3 Move the multi stick toward b or B repeatedly
to select “MD Set Up ?”, then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly
to select “PGM Check Clear ?”, then press
PUSH ENTER.
5 Move the multi stick toward b or B.
The track numbers appear in the order they
were programmed.
6 When you want to clear the displayed track,
press PUSH ENTER.
“Clear ?” appears in the display.
7 Press PUSH ENTER again.
The track displayed in step 5 is cleared from the
program.
To clear the entire program
1 Press FUNCTION repeatedly until “MD”
appears in the display.
2 While in stop mode, press MODE SELECT
repeatedly to select “Set Up Mode” then press
PUSH ENTER.
3 Move the multi stick toward b or B repeatedly
to select “MD Set Up ?”, then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly
to select “PGM Check Clear ?”, then press
PUSH ENTER.
5 Move the multi stick toward b or B repeatedly
to select “PGM All Clear” then press PUSH
ENTER.
“PGM All Clear ?” appears.
6 Press PUSH ENTER again. The entire program
is cleared.
Tips
• You can make a program using the “Play Mode Set
Up ?” menu. Select “Play Mode Set Up ?” in step 4,
then move the multi stick toward b or B repeatedly
to select “Program” and press PUSH ENTER. Then
follow steps 5 through 8.
• The program you made remains in the system’s
memory even after it has been played back. Press
MD NX to play the same program again.
• If you try to add more than the maximum number of
the program, “Step Full!” appears. Erase
unnecessary tracks and program again.
• “--m--s” appears when the total MD program time
exceeds 1000 minutes.
Notes
• The program remains in the memory until it is
cleared by following the steps of “To clear the
entire program”.
• You can change the play mode in stop mode only.
Programming the MD tracks
(continued)