Filter
Top Products
92
Troubleshooting (continued)
Speakers
Sound comes from one channel or
unbalanced left and right volume.
• Check the speaker connection and speaker
placement.
Sound lacks bass.
• Check that the speaker’s + and – jacks are
connected correctly.
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is inserted label side down.
• Moisture condensation has built up. Remove
the CD and leave the system turned on for
about an hour until the moisture evaporates.
Play does not start from the first track.
• The player is in program or shuffle mode.
Select “1 Disc” or “All Discs” in the “Play
Mode” menu (pages 27, 29).
“Over” is displayed.
• You have reached the end of the CD. Press
and hold m to return.
MD Deck
The display shows a code made up of
three or five letters and a message.
• This system has the Self-Diagnostic function
(see “Self-diagnosis Display” on page 94).
The disc will not be inserted.
• Insert the MD in the direction of the arrow.
The controls do not work.
• The MD is dirty or scratched. Replace the
MD with a new one.
The MD will not play.
• Moisture condensation has built up. Remove
the MD and leave the system turned on for
several hours until the moisture evaporates.
• Nothing is recorded on the MD.
Recording is not possible.
• The MD is protected against erasure. (“C11”
and “Protected” appear alternately.) Slide the
tab to close the slot (see page 37).
• Connect the sound source properly.
• A pre-recorded MD is in the deck. Replace
the disc with a recordable MD.
• Replace the disc with a recordable MD that
has sufficient time remaining or erase
unnecessary tracks.
• The power cord (mains lead) was unplugged
or a power interruption occurred during
recording. Start recording over from the
beginning.
“-Over-” is displayed.
• You have reached the end of the MD. Press
m to return to the beginning of the MD.
“OVER” lights up during recording.
• A strong signal was input during recording.
When the sound is distorted, reduce the
recording level (“Adjusting the recording
level” on page 46), then re-record.
“Repeat All” will not be selected.
• This sometimes occurs when the play mode of
the CD is set to “All Shuf”. Change the play
mode of CD.