Filter
Top Products
65
Recording on a Tape
x
8 Press TAPE REC PAUSE/START.
Recording starts.
9 Start playing the source to be recorded.
To Press
Stop recording x.
Pause recording TAPE REC PAUSE/START.
To cancel the menu operation
Press MODE SELECT.
Tips
• If you want to record from the reverse side, press
TAPE B n to light its indicator after pressing
TAPE REC PAUSE/START in step 3.
• When you want to reduce the hiss noise in low-level
high-frequency signals, do the following procedure
after pressing TAPE REC PAUSE/START in step
3.
1 Press MODE SELECT repeatedly to select “Set
Up Mode”, then press PUSH ENTER.
2 Move the multi stick toward b or B repeatedly
to select “TAPE Set Up ?”, then press PUSH
ENTER.
3 Move the multi stick toward b or B repeatedly
to select “DOLBY NR Set Up ?”, then press
PUSH ENTER.
4 Move the multi stick toward b or B repeatedly
to select “On”, then press PUSH ENTER.
“DOLBY NR” appears in the display.
To return to the original setting, repeat steps 1
through 4 and select “Off” in step 4.
• When recording from a CD or MD, you can use
. or > to select tracks during recording pause
mode (after pressing TAPE REC PAUSE/START
in step 3 and before pressing again in step 8).
Recording a CD by
specifying track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programming, make sure
the playing time for each side do not exceed the
length of one side of the tape.
?/1
(Power)
2
Multi stick
PUSH ENTER
16
1
1
3,13
10
continued