Message Cause and Solution
Received remote control ID
(n1). VC500
current setting is
(n2).
Press [Home] button using
the correct remote control, or
setup remote control as
follows.
1. Press [.] and [#] at the same
time
2. Within 2 seconds, press
[n2]
3. Press [Home] to finish, this
message will disappear.
If this message will not
disappear, please check the
batteries in your remote
control and try again.
Note
• The remote
control ID
of the remote control
(1/2/3) is represented
by n1.
• The remote control ID
of the KX-VC500 (1/2/
3) is represented by
n2.
• The remote control IDs of the KX-VC500 and remote control do not
match.
→ Follow the
on-screen instructions to change the remote control ID of the
remote control to match that of the KX-VC500.
→ If you cannot change the remote control ID of the remote control,
contact your dealer.
→ If multiple remote controls with assigned IDs will be used close together
or if you do not want this message to be displayed, select "OFF" for
"Check ID mismatch". (Page 68)
The IP Address is invalid.
Please enter a valid IP
Address.
• The IP address contains an invalid value.
→ Enter the IP address correctly. The correct format is
XXX.XXX.XXX.XXX (dotted format decimal notation).
If
the
IP address contains 1 or 2 digit numbers, enter these numbers as
they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
– Correct entry: [192.168.0.1]
– Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
Check the IP Address.
• The IP address of the other party is the same as your own IP address.
• The
same IP address is used for several parties in a multiple-party video
conference call.
→ Register the correct IP address.
→ Check the IP address registered in the contact list.
94 Operating Manual Document Version 2010-10
Additional Information