Filter
Top Products
75
SOLUTION
Connect an outdoor FM antenna or contact
your dealer. (See page 6.)
Select a new station.
Check with your dealer to be sure you have
the correct antenna.
Check connections. (See page 6.)
Move the antenna farther from automobile
traffic.
Connect it to the screw marked (H).
Move speakers away from the turntable.
Turn off the Line Direct function.
(See page 25.)
1. Press
(STANDBY/ON) on the front
panel to turn off the receiver.
2. Stop the playback source.
3. Turn on the receiver again, and adjust the
volume.
Press
(STANDBY/ON) on the front
panel to turn off the receiver, check the
speaker wiring, then press it again to turn on
the receiver again. If “OVERLOAD” does not
disappear despite speaker wiring is not short-
circuited, consult your dealer.
• Press MAIN ROOM ON/OFF for the main
room operations.
• Press SUB ROOM ON/OFF for the sub-
room operations.
Press
(STANDBY/ON) on the front
panel to turn off the receiver. After unplugging
the AC power cord, consult your dealer.
Set the selector correctly either to “MAIN
ROOM” or to “SUB ROOM.”
Set the selector correctly either to “TV” or to
“CATV/DBS.”
Set both the BAND selectors to the same band
(See page 15.)
Consult your dealer.
Replace batteries. (See page 16.)
Select the correct remote control operation
mode. (See pages 64 to 73.)
Remove the obstruction, and turn the unit off
then back on again.
POSSIBLE CAUSE
Incoming signal is too weak.
The station is too far away.
An incorrect antenna is used.
Antennas are not connected properly.
Ignition noise from automobiles.
A ground cable of the turntable is not
connected to the screw marked (H).
Your turntable is too close to speakers.
The Line Direct function is turned on.
Speakers are overloaded because of high
volume either in the main room or in the
sub-room.
Speakers are overloaded because of short
circuit of speaker terminals.
The receiver is turned on with the main
room and sub-room sounds deactivated.
The receiver is overloaded because of
applying high voltage.
The MAIN ROOM/SUB ROOM selector
is not set correctly.
The TV operation mode selector is not
set correctly.
The BAND selectors on the rear and on
the remote control are set to a different
band.
RF communication between the receiver
and the remote control is interrupted
from outside.
Batteries are weak.
An incorrect remote control operation
mode is selected.
There is an obstruction disabling the
front door from opening or closing.
PROBLEM
Continuous hissing or buzzing during FM
reception.
Occasional cracking noise during FM
reception.
Noise is heard during record playing.
Howling during record playing.
No sound effect such as DSP mode and
Parametric Equalizer.
“OVERLOAD” starts flashing on the display.
“TURN ON MAIN OR SUB ROOM”
appears on the display.
The STANDBY lamp lights up after turning
on the power, but soon the receiver turns off
again (into standby mode).
Remote control does not work.
Remote control does not work properly.
Front door does not open or close.
EN61-77_RX-DP10VBK[J]_f 01.6.19, 0:54 PM75