Filter
Top Products
74
Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC
service center.
POSSIBLE CAUSE
The power cord is not plugged in.
The Multi-room function is not set
correctly.
Speaker signal cables are not connected
properly.
The SPEAKERS 1 and SPEAKERS 2/
SUB ROOM buttons are not set correctly.
An incorrect source is selected for the
main room.
Muting is activated for the main room
source.
An incorrect input mode (analog or
digital) is selected.
Connections are incorrect.
Speaker signal cables are not connected
properly.
Main/sub setting for the speakers
connected to the FRONT 2/SUB ROOM
terminals are not set correctly.
Amplifier connected to the SUB ROOM
PREOUT is not turned on.
An incorrect source is selected for the
sub-room.
Muting is activated for the sub-room
source.
Connections are incorrect.
The Surround/DSP mode is used for the
main room.
Sub-room sound is activated (the SUB
ROOM indicator is lit on the display).
When the same source is selected both for
the main room and the sub-room, the
source in one room affects the source in
the other room.
Main room and sub-room operations are
done at the same time.
SOLUTION
Plug the power cord into an AC outlet. (See
page 16.)
• Press MAIN ROOM ON/OFF for the main
room operations.
• Press SUB ROOM ON/OFF and SUB
ROOM CONTROL for the sub-room
operations.
Check speaker wiring and reconnect if
necessary. (See page 8.)
Press SPEAKERS 1 and SPEAKERS 2 /SUB
ROOM correctly. (See page 23.)
Select the correct source for the main room.
Press MUTING to cancel the mute.
(See page 24.)
Select the correct input mode (analog or
digital). (See page 23.)
Check connections.
For analog connections, see pages 9 to 13.
For digital connections, see page 14.
Check speaker connection and reconnect if
necessary. (See page 17.)
Set the main/sub setting for the speakers
correctly to use them as the sub-room front
speakers. (See page 40.)
Turn on the amplifier.
Select the correct sub-room source.
Press MUTING to cancel the mute.
(See page 30.)
Check connections.
For analog connections, see pages 9 to 13.
Cancel the Surround/DSP mode in the main
room.
Deactivating the sub-room sound will allow
you to use the Surround in the main room.
This is normal, not the malfunction of the unit.
Selecting different sources for the main room
and the sub-room will avoid these troubles.
If this happens, perform the same operation
again.
PROBLEM
The display does not light up.
The buttons and controls on the front
panel do not work.
No sound from the speakers in the main
room.
No sound from the front speakers in the
sub-room.
The sub-room speaker connected to the
FRONT 2/SUB ROOM SPEAKERS
cannot be activated.
Surround cannot be used for the main
room sources.
CD tracks are skipped, tape is rewound,
or radio station is changed
unintentionally.
The receiver does not work correctly as
you operate it.
Continued on the next page.
EN61-77_RX-DP10VBK[J]_f 01.6.19, 0:54 PM74