Filter
Top Products
53
Using the DVD MULTI Playback Mode
This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD
player. Before playing back a DVD, refer also to the manual supplied for the DVD player.
• The following operations are only possible when the receiver is ready for the main room operations, and are
used only for the main room source—DVD MULTI.
Before you start, remember...
• Make sure that you have connected the DVD player to the analog
discrete input (5.1 CH reproduction) jacks on the rear (see page
13).
• When the SUB ROOM speaker indicator is lit on the display, the
DVD MULTI button does not work.
1. Press DVD MULTI so that “DVD MULTI”
appears on the display.
Note:
When you select “DVD MULTI” as the main room source to play,
the THX ON/OFF, SURROUND ON/OFF and DSP MODE buttons
do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you want to modify the stored sound adjustments
temporarily
See “Adjusting Surround Sounds Temporarily” on page 49.
• When adjusting the sounds for the DVD MULTI playback
mode, you cannot output the test tone.
• If “L/R” is selected on the SURROUND SPEAKERS submenu
(see page 38), you cannot adjust the output levels of the
surround back speakers.
DVD MULTI
On the remote control
On the unit
(inside the front door)
DVD MULTI
Activating the DVD MULTI Playback Mode
Perform the basic settings and adjustments using the Setup and
Adjustment Menus first (see pages 33 to 45).
Activating DVD MULTI playback mode automatically recalls
the memorized settings and adjustments done on the above
menus.
• You also need to set the DVD player to the analog discrete output
mode.
IMPORTANT:
Check to see if the following before or while using the buttons and
controls.
For the main room operations:
The MAIN ROOM ON/OFF lamp on the unit is lit.
• When using the unit:
–“SUB ROOM” is not shown in the main display.
–Press DOOR DOWN to use the buttons inside the
front door.
To close the front door, press DOOR UP.
• When using the remote control:
–Set the MAIN ROOM/SUB ROOM (LEARN/
TRANSMIT) selector to “MAIN ROOM.”
–Check the indication shown on the remote’s
display when you press a button on the remote
control—this indicates the remote control
operation mode together with multi-room
operation mode (either MAIN ROOM or SUB ROOM) for a while
(10 or 5 seconds.)
SUB ROOM
TRANSMITLEARN
MAIN ROOM
DOOR
DOWN
Ex.When you press DVD MULTI with
MAIN ROOM/SUB ROOM (LEARN/TRANSMIT)
selector set to “MAIN ROOM.”
ON/OFF ON/OFF
SUB ROOM
TRANSMITLEARN
MAIN ROOM
SUB ROOM
MAIN ROOM
MAIN ROOM
STANDBY
TV/CATV/DBS
STANDBY/ON STANDBY/ON
VCR 1
ON
EN46-53_RX-DP10VBK[J]_f 01.6.19, 11:38 AM53