Filter
Top Products
24
Attenuating the Input Signal
When the input level of the playing source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent sound distortion.
• You have to make this setting for each source.
On the unit ONLY:
Press and hold INPUT MODE/INPUT
ATT (inside the front door) so that the
INPUT ATT indicator lights up on the
display.
• Each time you press and hold the button, the input attenuator
mode turns on (“INPUT ATT ON”) or off (“INPUT ATT OFF”).
Notes:
• This effect is applied to only the main room sources connected to the
analog terminals.
• This function is not valid for the DVD MULTI playback mode.
Muting the Main Room Sound
From the remote control ONLY:
Press MUTING to mute the sound
through all speakers in the main room and
headphones connected.
“MUTING” appears on the display and the volume
turns off (the volume level indicator goes off).
To restore the sound, press MUTING again so that “MUTING
OFF” appears on the display for a while.
• Turning MASTER VOLUME on the unit or pressing VOLUME
+/– on the remote control also restores the sound.
L
ANALOG
SPEAKERS
VOLUME
INPUT
ATT
1
SUBWFR
R
dB
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
Ex. When the source is “VIDEO.”
INPUT MODE
/ INPUT ATT
MUTING
DIGITAL AUTO : Select this for the digital input mode.
The receiver automatically detects the
incoming signals.
The DIGITAL AUTO indicator lights up
on the display, and the digital signal format
indicators for the detected signals also
light up.
ANALOG : Select this for the analog input mode.
The ANALOG indicator lights up.
When selecting “DIGITAL AUTO,” the following indicators
indicate the digital signal format of the incoming signal.
LINEAR PCM
: Lights up when Linear PCM signals come in.
DIGITAL
: Lights up when Dolby Digital or Dolby Digital
EX signals come in.
: Lights up when DTS Surround or DTS-ES
signals come in.
No indicator lights up when the receiver cannot recognize the
digital signal format of the incoming signals.
When playing a software encoded with the Dolby Digital or DTS
Surround, the following symptoms may occur:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or
tracks.
In this case, press RIGHT (or LEFT) on the unit to select “DOLBY
DIGITAL” or “DTS” while “DIGITAL AUTO” still remains on the
display.
• Each time you press the button, the input mode changes as
follows:
When “DOLBY DIGITAL” or “DTS” is selected, the DIGITAL
AUTO indicator goes off, and the corresponding digital signal
format indicator (
DIGITAL
or ) lights up on
the display.
• If the incoming signal does not match the selected digital signal
format, the frame of the selected indicator will flash.
Note:
When you turn off the power or select another source, “DOLBY
DIGITAL” and “DTS” settings are canceled and the digital input mode
is automatically reset to “DIGITAL AUTO.”
L
ANALOG
SPEAKERS
1
SUBWFR
R
Ex. When the source is “VIDEO.”
The volume level
indicator goes off.
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
DIGITAL AUTO
DIGITAL
SPEAKERS
VOLUME
1
R
L
FE
R
S
dB
DIGITAL AUTO
DOLBY DIGITAL DTS
EN17-30_RX-DP10VBK[J]_f 01.6.19, 1:13 PM24