Filter
Top Products
7
AM Antenna Connections
Connecting the Speakers
You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to enjoy the surround effect.
• One pair of surround back speakers to enjoy 7.1 channel sound
reproduction.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One powered subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting information properly:
• To obtain the best possible Surround and DSP effect in the
main room, see “Basic Settings” on pages 33 to 40.
• To use the Multi-room function, see “Preparing for the
Sub-Room Operations—SUB ROOM” on page 40.
For each speaker (except for a subwoofer), connect the (+) and (–)
terminals on the rear panel to the (+) and (–) terminals marked on
the speakers. For connecting a subwoofer, see page 8.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Main room speaker layout
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.)
Surround back speakers
Left surround
speaker
Left front speaker(s)
Right front speaker(s)
Subwoofer
Center speaker
Right surround
speaker
Note:
When connecting the speakers for the sub-room, see also page 17.
ANTENNA
AM
EXT
AM
LOOP
FM 75
COAXIAL
2
3
1
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop.
Outdoor single vinyl-covered wire (not supplied)
Turn the loop until you
have the best reception.
AM Loop Antenna
EN01-16_RX-DP10VBK[J]_f 01.6.19, 0:25 PM7