Filter
Top Products
14
DVD
DIGITAL IN
DIGITAL 3 (TV)
DIGITAL 4 (CDR)
DIGITAL 5 (MD)
DIGITAL 2 (CD)
DIGITAL 1 (DVD)
DBS
Digital Connections
This receiver is equipped with five DIGITAL IN terminals—one
digital coaxial terminal and four digital optical terminals—and one
DIGITAL OUT terminal.
IMPORTANT:
• When connecting the DVD player, digital TV broadcast tuner, digital
VCR, or DBS tuner using the digital terminals, you also need to
connect it to the video terminal on the rear. Without connecting it to
the video terminal, you cannot view any playback picture.
• After connecting the components using the DIGITAL IN terminals,
set the following correctly if necessary.
– Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see “Setting the Digital Input Terminals—DIGITAL IN” on
page 38.
– Select the digital input mode correctly. For details, see “Selecting
the Analog or Digital Input Mode” on page 23.
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For CD player
– DIGITAL 3 (optical): For digital TV broadcast tuner
– DIGITAL 4 (optical): For CD recorder
– DIGITAL 5 (optical): For MD recorder
• When you want to operate the CD player, CD recorder, or MD
recorder using the COMPU LINK remote control system, connect
the target component also as described in “Analog connections”
(see page 10).
• When you want to operate the VCR or DVD player using the AV
COMPU LINK remote control system, connect the target
component also as described in “Analog connections” (see pages
11, 13).
• To use the digital source components as the sub-room source,
connect them using analog connection methods as well.
Digital input terminals
Digital TV
You can connect any digital component as follows:
DBS tuner
CD player
MD recorder
Digital VCR
Digital coaxial cable (not supplied)
between digital coaxial terminals
Digital optical cable (not supplied)
between digital optical terminals
Before connecting a digital
optical cable, unplug the
protective plug.
When the component has a digital
coaxial output terminal, connect it to the
DIGITAL 1 (DVD) terminal, using the
digital coaxial cable (not supplied).
When the component has a digital
optical output terminal, connect it to the
DIGITAL 2 (CD), DIGITAL 3 (TV),
DIGITAL 4 (CDR), or DIGITAL 5 (MD)
terminal, using the digital optical cable
(not supplied).
CD recorder
DVD player
PCM
/ DOLBY DIGITAL
/ DTS
DIGITAL OUT
Digital output terminal
Note:
The digital signal format of the signals output through the DIGITAL
OUT terminal is the same as that of the input signal. This means that
when the DTS Surround signals are input, the DTS Surround signals
are output.
When the digital recording
equipment such as an MD recorder
and a CD recorder has a digital
optical input terminal, connecting it
to the DIGITAL OUT terminal
enables you to perform digital-to-
digital recording.
MD recorder
CD recorder
Digital optical cable (not supplied)
between digital optical terminals
EN01-16_RX-DP10VBK[J]_f 01.6.19, 0:26 PM14