Filter
Top Products
73
To erase the stored signals
After erasing the stored signals, preset signals are resumed and you
can operate JVC’s components again.
1. Set the LEARN/TRANSMIT
(MAIN ROOM/SUB ROOM)
selector to “LEARN.”
2. Press and hold EXIT, then press one of the source
selecting buttons from which you want to erase
the stored signals.
“CLEAR” appears on the display, and all the signals stored in
the selected remote mode (source) are erased at the same time.
Notes:
• You cannot erase a signal assigned to a particular button only.
Storing a new signal to a particular button erases the previously
stored signal.
• To erase the stored signals for “CD DISC,” first press
CONTROL to select “CD DISC,” then press CONTROL again
while holding EXIT this time.
3. Set the LEARN/TRANSMIT (MAIN ROOM/
SUB ROOM) selector to “TRANSMIT (MAIN
ROOM/SUB ROOM)” to finish the erasing
procedure.
To use the stored signals
When you want to use the stored signals, follow the procedure
below.
1. Set the LEARN/TRANSMIT (MAIN ROOM/
SUB ROOM) selector to “TRANSMIT (MAIN
ROOM/SUB ROOM).”
2. Press one of the source selecting buttons (or
CONTROL repeatedly) to select the desired
remote control operation mode (source).
3. Press the desired button.
Notes:
• When you press TV/CATV/DBS
(STANDBY/ON)
, set the TV
operation mode selector correctly.
• To use the following buttons, you can skip step 2 above.
– VCR1
(STANDBY/ON)
, TV VOL +/–, TV/VIDEO, DVD
MENU
• To use the following buttons, press DVD MENU first.
– SET,
%
/
fi
/
@
/
#
For the main room
operations
For the sub-room
operations
IMPORTANT:
To operate the other component(s) using this remote control—
• Aim directly at the remote sensor(s) on the target component(s).
–This remote control can send signals at a distance of 7 m (23
feet).
OR
• You can also use the IR signal transmitter connected to this
receiver.
–Place the IR signal transmitter so that it is aimed at the remote
sensor(s) on the target component(s).
You can operate the other component(s) through the remote
sensor on this receiver.
When using the remote control:
–Set the MAIN ROOM/SUB ROOM (LEARN/TRANSMIT) selector to
“MAIN ROOM” or “SUB ROOM” correctly.
DVD
DVD MULTI
CD
CDR
PHONO
TAPE/MD
AM
VCR 1 VCR 2
FMVIDEOTV/DBS
SUB ROOM
TRANSMITLEARN
MAIN ROOM
SUB ROOM
TRANSMITLEARN
MAIN ROOM
SUB ROOM
TRANSMITLEARN
MAIN ROOM
CHANNEL
TV/VIDEO
TV VOL
SET
DVD
MENU
TUNING
STOP PAUSE
FF/
/ REW
REC
PLAY
DOWN UP
EFFECT
ROOM SIZE
FM MODE
RETURN
100
+
WALL
LIVENESS
123
456
7
/P
89
10
+
100
STANDBY/ON
TV/CATV/DBS
STANDBY/ON
VCR 1
LEARN
DVD
DVD MULTI
CD
CDR
PHONO
TAPE/MD
AM
VCR 1 VCR 2
FMVIDEOTV/DBS
and
EXIT
\
SUB ROOM
TRANSMITLEARN
MAIN ROOM
SUB ROOM
TRANSMITLEARN
MAIN ROOM
For the main room
operations
For the sub-room
operations
EXIT
and
EN61-77_RX-DP10VBK[J]_f 01.6.19, 0:54 PM73