Filter
Top Products
USP 507 • Reference Information
A-3
Nominal level ................................ 1 Vp-p for Y of component video and S-video, and for G of RGsB
0.8 Vp-p for SDI
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels
........ 0.0 V to 1.0 Vp-p
Impedance ...................................... 75 ohms
Scaled resolution ........................... 640x480
6,8,9
, 800x600
6,8,9
, 852x480
6,8,9
, 1024x768
6,8,9
, 1024x852
6,8,9
, 1024x1024
6,8,9
,
1280x768
6,8,9
, 1280x800
6,8,9
, 1280x1024
6,8,9
, 1360x765
6,8,9
, 1360x768
6,8,9
,
1365x768
6,8,9
, 1365x1024
6,8,9
, 1366x768
6,8,9
, 1400x1050
6,8
, 1440x900
6,8,9
,
1600x1200
6,8
, 1680x1050
6,8
, 1920x1200
6,8
HDTV: 480p
7,8
, 576p
6
, 720p
3,4,5,6,7,8
, 1080i
6,7,8
, 1080p
1,2,3,4,5,6,7,8
, 2048x1080
1,2,3,4,5,6,7,8
1
= 23.98 Hz,
2
= 24 Hz,
3
= 25 Hz,
4
= 29.97 Hz,
5
= 30 Hz,
6
= 50 Hz,
7
= 59.94 Hz,
8
= 60 Hz,
9
= 75 Hz
Sync
Input type ....................................... RGBHV, RGBS, RGsB, RGBcvS, and component video (tri-level or bi-level)
Output type .................................... RGBHV, RGBS, RGsB, and component video (tri-level or bi-level)
Standards ........................................ NTSC 3.58, PAL
Optional SDI/HD-SDI input: SMPTE 259M-C, SMPTE 292M
Input level
...................................... 2.75 V to 5.0 Vp-p for RGBHV or RGBS
0.6 Vp-p for component video tri-level sync
0.3 Vp-p for component video bi-level sync or RGsB
Output level
................................... 5.0 Vp-p for RGBHV or RGBS
0.6 Vp-p for component video tri-level sync
0.3 Vp-p for component video bi-level sync or RGsB
Input impedance
........................... Horizontal: 75 ohms
Vertical: 510 ohms
Output impedance
........................ 75 ohms
Polarity............................................ Positive or negative (selectable)
Control/remote— signal processor
Serial control port .......................... 2 RS-232/RS-422 on female 9-pin D connectors (rear panel)
1 RS-232, 2.5 mm mini stereo jack (front panel)
Baud rate and protocol
................. 9600 (default), 19200, 38400, 115200 baud, adjustable; 8 data bits, 1 stop bit,
no parity
Serial control pin configurations
9-pin D connector
.............. RS-232: 2 = TX, 3 = RX, 5 = GND
RS-422: 2 = TX-, 3 = RX-, 5 = GND, 7 = RX+, 8 = TX+
2.5 mm mini stereo jack
.... Tip = TX, ring = RX, sleeve = GND
Ethernet control port..................... 1 female RJ-45 connector
Ethernet data rate .......................... 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ........................... ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP, Telnet
Ethernet default settings .............. Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off
Web server
...................................... Up to 200 simultaneous sessions
40 MB nonvolatile user memory
Program control ............................. Extron control/configuration program for Windows
®
Extron Simple Instruction Set (SIS
™
)
Microsoft
®
Internet Explorer
®
, Telnet