Filter
Top Products
USP 507 • USP 507 Software
5-11
Advanced Settings tab
The Advanced Settings tab allows advanced functions to be configured. These
include test pattern selection and advanced features, used primarily during initial
setup.
Figure 5-5 — The Advanced Settings tab screen
• Test Pattern — Select any of the 14 test patterns to aid setting up an output
display device. A small thumbnail of the pattern is shown on the tab (see above).
Select Off where a test pattern is not needed.
• Advanced Features — Within this section:
RGB delay can be adjusted (from 0 to 5.0 seconds) in 0.1 second intervals with
each click of the scroll arrows.
A choice of three switch effects is available:
Cut (Blank) - image cuts to a black screen to mask the input switch,
Cut (Freeze) - image freezes to mask the input switch,
Fade - image fades out and the new input fades in.
Auto memory can be turned on or off.
If using MTP twisted pair devices, pre-peaking can be turned on to compensate
for long cable runs.
• Clock — In this section the clock display mode can be set or disabled, and the
on-screen horizontal and vertical position for the clock location can be adjusted.