Filter
Top Products
Front Panel Operation, cont’d
USP 507 • Front Panel Operation
3-10
Step 1
LCD screen displays
ADJUST
Rotate either
Adjust knob.
Recall to back:
<N/A>
UNDO/
CLEAR
MENU
NEXT
Press
twice
LCD screen displays
Recall:
IMG05.BMP
LCD screen displays
Recalling Image
Please wait
MENU
NEXT
Press
LCD screen displays
then
IMG05.BMP
Recalled
Step 2
UNDO/
CLEAR
MENU
NEXT
Press
three
times
Recall to front:
<N/A>
To remove an image from the display:
1. Press Next twice. The LCD displays “Recall to back: <N/A>”. If the image is
displayed at the front, press Next again so the LCD displays “Recall to Front:
<N/A>”.
2.
With the appropriate “Recall to back: <N/A>” or “Recall to front: <N/A>”
displayed, press Next. The current image is removed from the display, but
not from the USP 507 memory. To recall the image follow the steps described
in the “To recall an image” section, on this page.
Advanced configuration
Within this menu auto imaging and auto memory can be turned on or off, Input
EDID can be set, RGB delay value adjusted, the switch effect chosen, a test pattern
selected to aid setting up the display, and the MTP pre-peaking turned on or off.
In addition the internal temperature can be read, and the unit can reset to factory
default settings.
N
At any submenu, if the input is incorrect, press the desired input button, and
then proceed with the setting adjustment.
1. Press Next to enter the first sublevel, Auto Image. The
current active input and setting status is displayed. See the
table below for a full description of the interaction between
the auto image and auto memory settings.
Auto Memory and Auto-Image Features
Auto Memory Auto Image Information
ON ON
“New” signals /rates that have not been previously detected by the USP 507 are initially set-up
using default parameters, then auto image is automatically applied and values stored. The next
time the same signal is detected, the values stored in the auto memory location are applied.
ON
(Default)
OFF
(Default)
“New” signals /rates that have not been previously detected by the USP 507 are set-up using
default parameters. If manual input and/or picture settings are made to the input, an auto
memory location is created and recalled each successive time the input is detected.
OFF ON
Each change in input sync triggers an automatic auto image. When auto memory is disabled,
each different signal is treated as a new signal and default picture controls and automatic auto
image is applied. Any manual changes made to the image and picture controls are lost each time
a new rate is detected.
OFF OFF
Each change in input sync causes default values to be applied to the rate. Any manual changes
made to the image and picture controls are lost each time a new rate is applied.
Figure 3-6 — Auto Memory and Auto-Image features table
Auto Image
Input #2 On