Filter
Top Products
USP 507 • Front Panel Operation
3-3
f
Menu navigation buttons — These two buttons give access to menu
commands. See “The USP 507 Menu System” section in this chapter.
Menu button — This button, always lit amber, gives direct access to a series
of seven menus.
Next button — This button, always lit amber, allows page changes within
each one of the menus, and to exit the menu cycle.
g
Adjust knobs — These two knobs are used with the picture control buttons and
the menu navigation buttons to adjust settings.
Switching Inputs
To switch inputs, simply press the desired input button. The button lights amber
with an active video signal. If the output is configured correctly for the display
device, the image changes to the new input. An inactive signal gives no image.
Special Function Button Operation
To use the four special function buttons:
Mute — To mute (blank) the on-screen video image, press the Mute button
(lights green). Press it again to unmute the video (light extinguishes).
Freeze — To freeze the current on-screen image, press the Freeze button (lights
green). Press it again to unfreeze the image (light extinguishes).
Auto Image — To perform an auto image (sizing, centering, filtering) on the
active signal, press the Auto Image button once. The LCD displays
“Confirm... Press Auto Image”. Press it again to initiate the auto image,
the button lights green momentarily, then extinguishes when the auto
image action is complete.
PIP Preset — To recall any one of 16 PIP layout presets, press and release the PIP
Preset button. The LCD displays “Recall PIP preset: <N/A>”. Rotate
either adjust knob to reach the desired PIP preset number (for example
preset 02), then press Next. The LCD briefly displays “Preset 02
recalled!” (in this example), the layout is recalled to the current active
display, and the PIP input button lights green. The LCD shortly reverts
to the default display cycle.
1
3
2
4
1
7
3
2
4
8
5
6
7
9 10
Main = PIP =
Default PIP preset window positions (1-10)
To save a PIP layout preset, press and hold the PIP Preset button. The
LCD displays “ Save to PIP preset: <N/A>”. Rotate either adjust knob
to reach the desired PIP preset number (for example preset 05), then
press Next. The LCD briefly displays “Preset 05 saved!” (this example),
and the current active display layout is saved. The LCD reverts to the
default display cycle.
N
The Save PIP Preset function can be used only when the PIP feature is on.
Button Backlighting
The buttons can be backlit a dimmed amber.
To turn the backlighting on or off, press and hold the Bright/Cont and Color/Tint
buttons simultaneously until the buttons become lit or unlit.