Filter
Top Products
Front Panel Operation, cont’d
USP 507 • Front Panel Operation
3-4
Front Panel Operation
The USP 507 Menu System
The USP 507 can be configured using the menu system, via the Extron Simple
Instruction Set (SIS
™
) of commands through an RS-232 or LAN connected PC, or via
the Extron software program, SPPCP.
N
For SIS commands and SPPCP configuration methods see chapters 4 and 5.
There are seven front panel configuration menus: User Presets, Input Configuration,
Output Configuration, Image Capture/Recall, Advanced Configuration, and View
Comm Settings. A hidden menu (Edit Comm Settings) is also accessible
. If an optional
Scan Converter board is installed, an eighth menu (scan converter menu) is available.
User
Presets
Output
Configuration
Menu
Input
Configuration
Image
Capture/Recall
Menu
Menu
Menu
Menu
View Comm
Settings
Advanced
Configuration
Exit Menu
Press NEXT
Menu
Menu
Scan
Converter
only where optional Scan
Converter card is installed
Overview of menus
User Presets
This menu allows the user to save the current image settings to a preset number
(1-16 for each input), and recall any saved preset as the current image settings.
Input Configuration
This menu allows configuration of the following settings for any selected input:
Input type, film detection, vertical and horizontal start points, pixel phase, the
number of total and active pixels and the number of active lines.
Output Configuration
This menu allows configuration of the following settings for the active output:
resolution and refresh rate (see page 3-8), output type, and sync polarity.
Image Capture/Recall
This menu allows any one of up to 16 stored images to be recalled to the display, as
either a background to an active video signal, or in front of the active signal. It also
allows the user to store the current displayed image on the device for later recall.
Advanced Configuration
This menu allows advanced configuration of the following USP 507 settings:
auto image, input EDID, auto memories, RGB delay, switch effect, test pattern,
MTP pre-peaking, internal temp (view only), and resetting to factory defaults.
View Comm Settings
This menu allows the user to view the following serial and IP settings for the unit:
serial port baud rate, MAC address, DHCP (Dynamic Host Configuration Protocol)
setting, IP address, subnet mask address, and gateway address.
N
These settings can not be edited from within this menu. See next section.
Edit Comm Settings (hidden)
To display and enter this menu, press and hold the Detail and Color/Tint buttons
simultaneously and then press Next. The hidden menu appears.
This menu allows the user to edit the following serial and IP settings:
serial port baud rate, DHCP mode, IP address, subnet mask, and gateway address.
Scan Converter Configuration
This menu, displayed only when the optional scan-converter board is installed,
allows the user to configure the settings for scan-converted outputs.
Exit Menu
At this menu pressing Next exits the menu system and returns to the default cycle.