Filter
Top Products
USP 507 • SIS Programmer’s Guide
4-13
Command ASCII command
(host to processor)
Response
(processor to host)
Additional description
Auto Memory
Enable
E1AMEM}
Amem1
]
Set auto memory on. Previous
settings for incoming signal are
auto recalled.
Disable
E0AMEM}
Amem0
]
Set auto memory off. Default
settings are always used
unless input preset is recalled
manually.
View setting
EAMEM} X1)]
View auto memory status.
Advanced Configurations
Test pattern
Set test pattern
E
X2)TEST}
Test
X2)]
Select test pattern
X2)
.
View test pattern
ETEST} X2)]
View selected test pattern.
Freeze
Enable 1F
Frz1
]
Freeze selected input.
Disable 0F
Frz0
]
Unfreeze selected input.
View setting
F
X1)]
View freeze setting.
RGB delay time
Set value
E
X3&VDLY}
Vdly
X3&]
Set RGB delay.
View setting
EVDLY} X3&]
View RGB delay setting.
Switch effect
Cut (Blank)
E0SWEF}
Swef0
]
Cuts to black between inputs to
mask switch effect.
Cut (Freeze)
E1SWEF}
Swef1
]
Freezes image between inputs
to mask switch effect.
Fade
E2SWEF}
Swef2
]
Fades through to black then
fades in image.
View setting
ESWEF} 0] (or 1]) (or 2])
View effect setting.
MTP Pre-peaking
Enable
E1OPEK}
Opek1
]
Enables pre-peaking on the
MTP output.
Disable
E0OPEK}
Opek0
]
Disables pre-peaking on the
MTP output.
View setting
EOPEK} X1)]
View pre-peaking setting.
Front panel lockout (executive mode)
Enable mode 1 1X
Exe1
]
Limited front panel
adjustments only.
Enable mode 2 2X
Exe2
]
Lock out entire front panel.
Disable 0X
Exe0
]
Adjustments and selections can
be made from front panel.
View front panel lock status X
0
] (or 1]) (or 2])
Show executive mode status.
N
For full lock mode details, refer to chapter 3, “Setting the Front Panel Locks (Executive Modes).
N
X1)
= Off/disable/none (0), on/enable (1)
X2)
= Test patterns: 0 = off (default), 1 = color bars, 2 = crosshatch, 3 = 4x4 crosshatch, 4 = grayscale,
5 = ramp, 6 = alternating pixels, 7 = white field, 8 = crop, 9 = 1.33 aspect ratio,
10 = 1.78 aspect ratio, 11 = 1.85 aspect ratio, 12 = 2.35 aspect ratio, 13 = safe area,
14 = blue mode
X3&
=
RGB delay 0 to 50, in 0.1 second increments (default is 05 = 0.5 seconds)