Filter
Top Products
USP 507 Software, cont’d
USP 507 • USP 507 Software
5-10
• User Presets — A user preset saves specific settings for color, brightness, detail,
size, zoom and pan, and centering and up to 16 user presets per input are
available. These settings can then be recalled and applied to an applicable input.
Select a preset number and click Save or Recall as desired.
• PIP Presets — A PIP preset saves specific layout settings for location and size of
the PIP and main windows. These settings can be recalled and applied to any
applicable input. Select any one of up to 16 preset numbers and click Save or
Recall as desired.
I/O Configuration tab
The I/O Configuration tab allows input and output configuration, as well as EDID
emulation settings to be adjusted.
Figure 5-4 — The I/O Configuration tab screen
• Input Config — Set a suitable video type for an input by clicking on the drop-
down box (see input 4 above) and selecting a listed video type.
If Auto Image on an input is desired mark the check box.
Check Film Mode if 3:2 pull down detection for NTSC and 2:2 film detection for
PAL video sources is relevant.
N
Input 7 is shown when an optional input card has been installed.
• Output Config — To configure an output’s resolution, refresh rate, output type,
or sync polarity, select the desired values from the respective drop-down lists.
• EDID Emulation — To set resolution and refresh rates for EDID emulation on
the VGA/DVI inputs, select the values from the drop-down list. Alternatively
select Match Output to automatically set the EDID to match the output resolution
and refresh rate.