Filter
Top Products
5-3
USP 507 • USP 507 Software
3. If you selected TCP/IP tab in step 2, the TCP/IP Connection window
appears.
a. Examine the IP Address field, which displays the last IP address entered, or
the drop-down box which lists the most recently used IP addresses.
If listed, select the applicable IP address, or enter the correct IP address in the
field.
N
192.168.254.254 is the factory-specified
default IP address.
b. If the unit is password protected, enter the
appropriate administrator or user password in
the Password field.
c. Click Connect. The Control Program is
ready for operation.
Using the Program
The Signal Processing Products Control Program (SPPCP) is used to configure and
operate the USP 507 from the PC on which the program resides.
Orientation
The SPPCP main window (figure 5-1) has four tabs: Control, I/O Configuration,
Advanced Settings, Image Capture.
A fifth tab appears if an optional scan converter
board is installed. Click on each tab as desired.
The menu bar on the main window shows File, Options, Tools, and Help. Click on each
as desired.
At the bottom of the window is the status bar, indicating the status of the
connection or any configuration error messages.
N
For detailed Signal Processing Product Control Program instructions when the
program is open; press F1 or click on Help, Contents.
Figure 5-1 — The control program main window