Extron electronic USP 507 Stereo System User Manual


 
USP 507 Software, cont’d
USP 507 • USP 507 Software
5-8
6. Click Begin. The file uploads to the USP 507 and the upload progress can
be seen on the Total Progress bar.
7. When the file upload is complete (after file verification and the USP 507
restarting), click on the X at top right, or on File > Exit to exit the Firmware
Loader. The SPPCP window restores itself.
8. Connection to the USP 507 must be reestablished since the connection is lost
during firmware upload. Open the SPPCP Connect dialog box and re-enter
the connection information to re-establish communication with the USP 507.
Help menu
Click on the SPPCP Help to open a drop-down menu
displaying five selectable options: Contents, Extron
Home Page, Check for Updates, Unit Info..., and
About....
Contents — Select this (or press F1) to bring up the
Help file which gives step-by-step instructions to
configure the USP 507 using the SPPCP program. The
Help file opens in a separate window (see figure 5-2). Select the subject matter
from the contents section at the left side of the window.
Figure 5-2 — The SPPCP Help file’s main window
Extron Home Page — Select this to open the Extron Web site
(www.extron.com) home page. From this link, device firmware and necessary
applications such as Firmware Loader and IP Link File Manager can be
downloaded, and supporting documentation for Extron products can be viewed.
Check For Updates — Select this to update the software control program
(SPPCP). If an update is available follow any on-screen instructions to install it.
A dialog box appears if no updates are currently available. Click OK or the X in
the window’s top right corner to close it.