Filter
Top Products
60
UA-20 application guide
Recording an analog signal from an audio device
fig.aux.e
The sound that is input to Input jack L(MONO) will be recorded on the left channel, and
the sound that is input to R jack will be recorded on the right channel.
Use the Input volume to adjust the input level.
Check the input level on the application that you are using.
If you turn the input monitor switch to ON, the sound will be output from the
headphone jack and the master output jacks.
LINE OUT
Signal flow
Adjust the
input level.
Turn on if you
want to monitor.
Set this to
LINE.
Stereo Set
Be careful of looped connections
fig.loop.e
If the UA-20 is connected as shown above to a device that outputs (“thru-s”) the input
audio (such as a cassette player that is in recording mode), turning on the Input
monitor switch will cause the sound to loop between the UA-20 and the other device,
causing oscillation and producing an unexpectedly high volume. Be aware that such
connections may cause the system to malfunction, or your speakers to be damaged.
Stereo Set
(cassette player)
LINE OUT
LINE OUT
LINE IN
LINE IN
Loop Connection
UA-20