Filter
Top Products
45
Español Italiano Français Deutsch English
Getting Connected and Installing Drivers (Macintosh)
OMS settings
To check the OMS settings, you will first need to connect a
MIDI sound module to the UA-20's MIDI OUT connector.
For details on connecting a MIDI sound module, refer to the
owner's manual for your MIDI sound module.
1
Set the UA-20’s ADVANCE (mode select) switch to
the ON position.
2
Use the USB cable to connect the UA-20 to your
computer.
3
From the CD-ROM, drag the
Driver E–OMS Driver–
Settings folder into the
Opcode–OMS folder on the
hard disk of your Macintosh to
copy it there.
4
In the Opcode-OMS
Application folder where you
installed OMS, double-click
OMS Setup to start it up.
fig.03-omsusb1a.e
5
If a dialog box
like the one
shown here
appears, click
[Turn It Off]. A
confirmation
dialog box will
then appear, so
click [OK].
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.