Filter
Top Products
26
Getting Connected and Installing Drivers (Windows)
13
Use the USB cable to connect the UA-20 to your
computer.
fig.05-8e_30
14
The Insert Disk
dialog box will
appear.
Click [OK].
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
If the “File signature verification” setting was not set
to “Ignore”, a “Digital Signature Not Found” dialog
box will appear.
If “File signature verification” is set to “Warn,”
1. Click [Yes].
2. Continue the installation.
If “File signature verification” is set to “Block”
1. Click [OK].
2. When the “Found New
Hardware Wizard”
appears, click [Finish].
3. Perform the installation as
described in the
“Troubleshooting” section on Device Manager
shows “?”, “!”, or “USB Composite Device”
(p. 68).
If the Insert Disk dialog box
does not appear, please read
The “Insert Disk” dialog box
does not appear (p. 68).