Filter
Top Products
44
Getting Connected and Installing Drivers (Macintosh)
■ Installing the UA-20 driver (OMS)
Use the following procedure to install the UA-20 driver.
The included UA-20 OMS driver is an add-on module for
using the UA-20 with OMS. In order for you to use it, OMS
must already be installed on the hard disk from which
you started up.
If you would like to learn more about OMS, refer to
OMS_2.3_Mac.pdf in the OMS Driver folder within the
Driver E folder of the CD-ROM. You will need the Adobe
Acrobat Reader in order to view OMS_2.3_Mac.pdf.
* Disconnect the UA-20 from the Macintosh before you perform the
installation.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
3
Double-click the UA-20 OMS Driver-E Installer icon
(found in the Driver E–OMS Driver folder of the
CD-ROM) to start up the installer.
4
Verify the Install Location, and click [Install].
fig.03-scdrv2Z.e
5
If a message like
the following is
displayed, click
[Continue].
The other currently
running applications will exit, and installation will continue.
6
A dialog box will indicate Installation completed.
Click [Restart] to restart your Macintosh.
OMS can be found in the OMS
Driver folder within the Driver
E folder of the CD-ROM.
The indication for the
installation location will differ
depending on your system.
Make sure that the startup disk
for the system you are using is
selected.