Filter
Top Products
20
Getting Connected and Installing Drivers (Windows)
11
Set the UA-20’s ADVANCE (mode select) switch
to the ON position.
12
Use the USB cable to connect the UA-20 to your
computer.
Near the task bar, your computer will indicate “Found New
Hardware”. Please wait.
fig.2-6
13
The Found New
Hardware Wizard will
appear.
Make sure that the screen
indicates “EDIROL UA-20
(WDM)”, select “Install
from a list or specific
location (Advanced)”, and
click [Next].
fig.2-7
14
The screen will indicate
“Please choose your
search and installation
options”.
Select “Don’t search. I will
choose the driver to
install”, and click [Next].
fig.2-8_20
15
Make sure that the
“Model” field indicates
“EDIROL UA-20
(WDM)”, and click
[Next]. Driver
installation will begin.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
In the case of the MME driver,
make sure that “EDIROL
UA-20 (MME)” is displayed.
In the case of the MME driver,
make sure that “EDIROL
UA-20 (MME)” is displayed.