Filter
Top Products
53
Español Italiano Français Deutsch English
Getting Connected and Installing Drivers (Macintosh)
Installing the OS-standard driver
1
With the UA-20 disconnected, start up Mac OS.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
fig.05-35e_30
3
After starting up Mac OS, select
Apple System Profiler from the
Apple menu.
The “Apple System Profiler” dialog box will appear.
4
Click the Devices and Volumes tab.
5
Set the UA-20’s ADVANCE (mode select) switch to
the ON position.
6
Use the USB cable to connect the UA-20 to your
computer.
7
Wait for approximately five seconds.
The UA-20 will use the driver included with Mac OS.
While you are waiting, the screen display will not change, but
the UA-20 is being detected. Do not touch the mouse or
keyboard.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.