Filter
Top Products
Hardware Implementation
Quantum DLT 7000 Tape Drive 2-13
2.3 CONFIGURING AND INSTALLING A TABLETOP DRIVE
This section provides instructions for configuring and installing the tabletop
version of the tape drive.
2.3.1 Configuring the Tabletop Drive
Figure 2-6 shows the location of the controls and connectors for the tabletop
version of the drive. Note that this drive is normally configured to meet customer
specifications before leaving the factory so should not require any internal
configuration changes on-site.
Figure 2–6 Tabletop Back Panel
SCSI ID - The SCSI ID default for the tabletop drive is set to 5; the drive can be
configured for SCSI ID addresses that range from 0 to 15 using the SCSI ID
pushbutton. Press the button above or below the ID number display to set the
desired SCSI ID. The top button increases the ID number; the bottom button
decreases the ID number.
TERMPWR and/or Parity Check - The tabletop version of the drive can be
internally configured to supply TERMPWR or parity checking. Contact your
service representative if you want to change either of these settings on the
tabletop version of the drive.
SCSI ID Pushbutton
Power Switch
Power Connector
SCSI Connector (2)