Filter
Top Products
SCSI Commands
Quantum DLT 7000 Tape System 5-93
MODE SELECT (6) / (10) Command (15h) / (55h) (continued)
Table 5–47 EEPROM Vendor Unique Page Parameters (continued)
Name Value
Rep.
Default Length
(Bytes)
Usage
ENBINQMEDCHGR ASCII
Binary
0 1 0 = Disable media changer bit
1 = Enable media changer bit in byte 6 of
INQUIRY data (set if drive is in a media
changer device)
FORCECOMP ASCII
Binary
0 1 0 = automatic
2
1 = Always compress unless front panel
selection disables it
FORCEDENSITY
1
ASCII
Decimal
0 1 0 = automatic
2
1 = DLT 260
2 = DLT 600
3 = DLT 2000
4 = DLT 4000
5 = DLT 2000XT
6 = DLT 7000
FORCEEEREBUILD ASCII
Binary
0 1 To force all the EEPROM parameters to
reset to default, if set. WARNING: This
causes all Log Sense history to be reset
and may cause power-on hours entry to
be reset.
FORCEREADSILI ASCII
Binary
0 1 To make variable READ command
handled as if the SILI bit is set if set.
HOSTCOMPSETTING ASCII
Decimal
0 1 This parameter allows the host to change
the compression setting. Note that there
is a tradeoff between best performance
and best compression; if the compression
setting is 1 it provides the best
performance but the worst level of
compression. If the compression setting is
3, it provides lowest performance but
maximum compression. Settings for the
HOSTCOMPSETTING parameter are: