Filter
Top Products
SCSI Commands
Quantum DLT 7000 Tape System 5-101
5.10 MODE SENSE (6) / (10) COMMAND (1Ah / 5Ah)
The MODE SENSE command allows the drive to report its media type, and
current, or changeable configuration parameters to the host. It is a
complementary command to MODE SELECT.
The command descriptor block for the 6-byte MODE SENSE (1Ah) is shown
below. An illustration of the command descriptor block for the 10-byte MODE
SENSE (5Ah) follows on the next page.
Bit
Byte
7 6 5 4 3 2 1 0
0 Operation Code (1Ah)
1 Logical Unit Number Rsv’d DBD Reserved
2 PC Page Code
3 Reserved
4 Allocation Length
5 Unused Reserved Flag Link
Figure 5–47 MODE SENSE (6) Command Descriptor Block - Data Format
The 10-byte MODE SENSE command is required to request the Vendor-Unique
EEPROM parameter page due to the large amount of data that parameter page
contains. MODE SENSE (10) can be used to retrieve the other pages as well.
Note that MODE SENSE (10) returns descriptor data in a different format than
MODE SENSE (6).