Filter
Top Products
SCSI Commands
5-96 Quantum DLT 7000 Tape System
MODE SELECT (6) / (10) Command (15h) / (55h) (continued)
Table 5–47 EEPROM Vendor Unique Page Parameters (continued)
Name Value
Rep.
Default Length
(Bytes)
Usage
PROTECTDIRONWP ASCII
Binary
0 1 To protect tape directory if the cartridge
write-protect switch is in its write protect
position.
REDUNDANCYMODE ASCII
Decimal
0 1 Sets the value of the allowed maximum
marginal channel (0 or 1 allowed).
REPBUSYINPROG ASCII
Binary
0 1 When set, report busy status if the drive is
in the process of becoming ready.
REPORTRCVDPERRS ASCII
Binary
1 1 To report recovered error if parity error
has been retried successfully, if set.
REPORTRCVRDERR ASCII
Binary
0 1 This parameter sets the default value of
PER bit of READ / WRITE Error Recovery
Mode page (01h).
REPUAONSEQUNLD ASCII
Binary
0 1 When set, the drive reports a Not Ready to
Ready Unit Attention when an autoloader
loads the next cartridge
REWINDONRESET ASCII
Binary
1 1 0 = Do not rewind on BUS RESET or BDR
message (CAUTION: May have partial
block data written to tape if reset occurs
during WRITE).
1 = Rewind the tape medium to BOT on
reset.
SCSIBUSDMATIMER ASCII
Decimal
2 1 The number of seconds until the drive
times out waiting for ACK once DMA
transfer started. When set to 0, the timer
is set to infinite.
SCSIINQVS ASCII
Binary
0 1 To return vendor unique inquiry string, if
set.
SCSIRDYEARLY ASCII
Binary
0 1 The drive reports READY status earlier (if
set).