Filter
Top Products
Hardware Implementation
Quantum DLT 7000 Tape Drive 2-9
2.2.4.2 Connecting the Rackmount Drive Cables
The three external connectors on the DLT 7000 tape drive that are discussed in
this manual are the SCSI, power and optional loader connectors. Tabletop
connectors are described in subsection 2.3.
SCSI and Power Connectors (Rackmount)
Figure 2-4 shows the pin orientation for the 68-pin SCSI connector and 4-pin
power connector located on the back of the tape drive. Pin assignments for the
single-ended and differential SCSI connectors are listed in Tables 2–2 and 2-3; pin
assignments for the power connector are listed in Table 2-4.
Align the appropriate SCSI and power cables to their matching connectors.
Carefully connect the cables, to avoid bending or damaging the connector pins.
Figure 2-4 SCSI and Power Cable Connectors (Rackmount Version Shown)
4-Pin Power Connector
Pin 1
Drive Back
SCSI-2 Connector
Pin 1