Filter
Top Products
SCSI Commands
5-92 Quantum DLT 7000 Tape System
MODE SELECT (6) / (10) Command (15h) / (55h) (continued)
Table 5–47 EEPROM Vendor Unique Page Parameters (continued)
Name Value
Rep.
Default Length
(Bytes)
Usage
ENACLNGLTRPT ASCII
Binary
1 1 To report error status if cleaning indicator
is on.
ENAGRANULARITY ASCII
Binary
1 1 Enables granularity field in READ BLOCK
LIMITS command.
ENAINITSYNCNEG ASCII
Binary
0 1 To enable target-initiated synchronous
negotiation, if set.
ENALDRAUTOLD ASCII
Binary
1 1 To turn on/off sequential loading with
loader.
ENAMODEPG22 ASCII
Binary
0 1 To enable vendor unique Data
Compression (Status Mode Page)
ENAPARERRRETRY ASCII
Binary
0 1 To turn on/off parity error retry feature
ENAREPDECOMP ASCII
Binary
0 1 If set and the drive is in READ mode, the
decompression algorithm field in Data
Compression mode will be reset if the last
block requested by the host was
decompressed, otherwise it is cleared.
ENAREQACKACTNEG ASCII
Binary
1 1 Enables active negation on REQ and ACK
signals.
ENASCSIFILTER ASCII
Binary
1 1 Enables SCSI filter on SCSI chip.
ENASCSIUNLONPMR ASCII
Binary
0 1 When set, enables a SCSI Unload when a
previous Prevent Media Removal
command is in effect
ENATHIRDPTYDENS ASCII
Binary
1 1 To make non-DLT density code act as the
default density (same as density code 0),
if set.