Filter
Top Products
Quantum DLT 7000 Tape Drive 2-1
Chapter 2
HARDWARE IMPLEMENTATION
This chapter describes how to install the integratible tape drive or “brick” into a rackmount system.
This includes configuration jumper settings, connector pin assignments, installation instructions,
power and signal cabling descriptions, and operating instructions. This chapter also includes
information on configuring and connecting the tabletop version of the drive into a system.
This chapter covers the following topics:
• Safety, Handling and Electrostatic Discharge (ESD) Protection (Section 2.1)
describes appropriate guidelines when working with the tape drive.
• Configuring and Installing a Rackmount Tape Drive (Section 2.2) describes
how to configure and install an integratible tape drive into a host system,
expansion cabinet, or other chassis.
• Configuring and Installing a Tabletop Drive (Section 2.3) describes how to
configure and install the tabletop version of the tape drive.
• Drive Controls and Light Emitting Diodes (LEDs) (Section 2.4) identifies
the front panel controls and LEDs and describes their functionality. It also
explains density selection.
• Power On Self Test (POST) (Section 2.5) describes the activities that occur
when power is first applied to the drive.
• Troubleshooting (Section 2.6) lists troubleshooting tips in the event that the
tape drive fails.
2.1 SAFETY, HANDLING AND ELECTROSTATIC DISCHARGE (ESD) PROTECTION
Inappropriate or careless handling of tape drives may result in damage to the
product. Follow the precautions and directions to prevent damaging the tape
drive.