Filter
Top Products
Hardware Implementation
Quantum DLT 7000 Tape Drive 2-3
2.1.3 Electrostatic Discharge (ESD) Protection
Various electrical components on/within the tape drives are sensitive to static
electricity and Electrostatic Discharge (ESD). Even a static buildup or discharge
that is too slight to feel can be sufficient to destroy or degrade a component's
operation.
To minimize the possibility of ESD-related damage to the drive, we strongly
recommend using both a properly installed workstation anti-static mat and a
properly installed ESD wrist strap. When correctly installed, these devices reduce
the buildup of static electricity that might harm the drive.
Observe the following precautions to avoid ESD-related problems:
• Use a properly installed anti-static pad on your work surface.
• Always use a properly fitted and grounded wrist strap or other suitable ESD
protection when handling the drive and observe proper ESD grounding
techniques.
• Hold the drive only by its sides. Do not touch any components on the
PCBA.
• Leave the drive in its anti-static bag until you are ready to install it in the
system.
• Place the drive on a properly grounded anti-static work surface pad when it
is out of its protective anti-static bag.
• Do not use the bag as a substitute for the work surface anti-static pad. The
outside of the bag may not have the same anti-static properties as the
inside. It could actually increase the possibility of ESD problems.
• Do not use any test equipment to check components on the PCBA. There are
no user-serviceable components on the drive.
2.2 CONFIGURING AND INSTALLING A RACKMOUNT TAPE DRIVE
This section provides information for configuring and installing a tape drive that
is integrated into a host system, expansion cabinet, or other chassis. For
information for configuring and installing a tabletop tape drive, see Section 2.3.
WARNING
Before you begin, review the Safety, ESD, and Handling precautions
described at the beginning of this chapter to avoid personal injury
or damage to equipment.