About the demo mode
This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.
! When the source is off, you can check the
location of 5 and 6 by turning on the fea-
ture demo.
Important
The red lead (ACC)of this unit should becon-
nected to a terminalcoupled with ignition switch
on/off operations. If thisis not done, the vehicle
battery may be drained.
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing 5 numbered button when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON cancels the re-
verse mode. Pressing 5 numbered button
again to start the reverse mode.
Feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing 6
numbered button during feature demo opera-
tion cancels the feature demo mode. Pressing
6 numbered button again to start the feature
mode. Remember that if the feature demo
continues operating when the car engine is
turned off, it may drain battery power.
About basic displays
This unit is equipped with three forms of basic
display. You can select the desired display.
FORM1
FORM2
FORM3
Note
For details,refer to Changing thedisplay form on
page 61.
Before You Start
En
7
English
Section
01