Filter
Top Products
Selecting tracks from the
track title list
The track title list lets you see the list of track
titles on a CD TEXT disc and select one of
them for playback.
1 Press FUNC and then press T.LIST to se-
lect the track title list mode.
2 Press NEXT to display the desired track
title.
Press NEXT until the desired track title ap-
pears.
3 Press the corresponding number button
to select the desired track title.
That selection will begin to play.
Notes
! You canalso use c, d and ato select and
play the desiredtrack title.
! Only when playinga CD TEXT disc, youcan
switch to this mode.
Pausing CD playback
Pause lets you temporarily stop playback of
the CD.
1 Press FUNC and then press PAUSE to se-
lect the pause mode.
2 Press PAUSE to turn pause on.
The light illuminates. Play of the current track
pauses.
# Toturn the pause off,press PAUSE again.
Note
You canalso turn pause on or offby pressing
PAUSEin the following display.
Selecting the search method
You can switch the search method between
fast forward/reverse and searching every 10
track.
1 Press FUNC and NEXT and then press
R.SRCH to select the search method mode.
2 Press R.SRCH to select the search meth-
od.
Press R.SRCH until the desired search method
appears in the display.
! FF/REV Fastforward and reverse
! Rough search Searching every 10
track
Searching every 10 track in
the current disc
If a disc contains over 10 tracks, you can
search every 10 track. When a disc contains a
lot of tracks, you can roughly search the track
you want to play.
1 Select the search method Rough search.
Refer to Selecting the search method on this
page.
Built-in CD Player
En
21
English
Section
05