Filter
Top Products
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
Setting the high pass filter for
front speakers
1 Press AUDIO and NEXT and then press
HPF F to select the high pass filter mode.
2 Press HPF F to turn high pass filter on.
HPF ON appears in the display. High pass fil-
ter is now on.
# Toturn high pass filteroff, pressHPF F again.
3 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Setting the high pass filter for
rear speakers
1 Press AUDIO and then press NEXT
twice.
2 Press HPF R to select the high pass filter
mode.
3 Press HPF R to turn high pass filter on.
HPF ON appears in the display. High pass fil-
ter is now on.
# Toturn high pass filteroff, pressHPF R again.
4 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (Refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 54).
You can turn the auto-equalizer on or off.
1 Press AUDIO and NEXT and then press
A.EQ to select the auto-equalizer on/off
mode.
# A.EQ is inactive ifauto TA and EQ hasnot
been carried out.
2 Press A.EQ to turn the auto-equalizer
on.
Auto EQ ON appears in the display.
# Toturn auto-equalizer off, pressA.EQ
again.
Recalling equalizer curves
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
There are seven stored equalizer curves which
you can easily recall at any time.
1 Press EEQ to switch to the easy equali-
zer mode.
2 Press NEXT to switch between CSTM2
and the other selections (curves).
Audio Adjustments
En
50
Section
11