Filter
Top Products
M HPF: 31.540506380100125
160200 (Hz)
M LPF: 1.622.53.15456.38
1012.516 (kHz)
H HPF: 1.622.53.15456.38
1012.516 (kHz)
4 Press a or b to adjust the level of the
selected speaker unit (filter).
Each press of a or b increases or decreases
the level of the selected speaker unit (filter).
0dB 24dB is displayed as the levelis in-
creased or decreased.
+6dB 24dB is displayed as the levelis in-
creased or decreased, only if you haveselected
L LPF.
5 Press SLOPE to select the slope of the
selected speaker unit (filter).
L LPF: 12 18 6 (dB/oct.)
M HPF: 12 18Pass (0) 6 (dB/oct.)
M LPF: 12Pass (0) 6 (dB/oct.)
H HPF: 12 6 (dB/oct.)
6 Press PHASE to switch the phase of the
selected speaker unit (filter).
Each press of PHASE switches the phase be-
tween normal
and reverse .
# You canadjust the parameters for other
speaker units (filters)in the same way.
7 Press BAND to cancel the network ad-
justment mode.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Press AUDIO and NEXT and then press
SW1 to select the subwoofer output mode.
# SW2 is displayedonly when the subwoofer
output is onin the subwoofer output mode
(SW1).
2 Press SW1 to turn subwoofer output
on.
SUB.W ON appears in the display. Subwoofer
output is now on.
# Toturn subwoofer output off,press SW1
again.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase. Press d to se-
lect normal phase.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO and NEXT and then press
SW2 to select the subwoofer setting mode.
2 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
3 Press a or b to adjust the output level
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6 24 is dis-
played as the level is increased or
decreased.
Audio Adjustments
En
49
English
Section
11