Pioneer FH-P9200MP Stereo System User Manual


 
Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an
error message appears on the display refer to
the table below to see what the problem is and
the suggested method of correcting the pro-
blem. If the error cannot be corrected, contact
your dealer or your nearest Pioneer Service
Center.
Message Cause Action
ERROR-11, 12,
17, 30
Dirty disc Clean disc.
ERROR-11, 12,
17, 30
Scratched disc Replacedisc.
ERROR-10, 11,
12, 17,30,A0
Electrical orme-
chanical
Turnthe ignition
ON andOFF,or
switch to adiffer-
ent source,then
back totheCD
player.
ERROR-22, 23 The CDformat
cannot beplayed
back
Replacedisc.
ERROR-44 All tracks are
skip tracks
Replacedisc.
Understanding built-in MD
player error messages
When problems occur during MD play an
error message may appear on the display. If
an error message appears on the display refer
to the table below to see what the problem is
and the suggested method of correcting the
problem. If the error cannot be corrected, con-
tact your dealer or your nearest Pioneer Ser-
vice Center.
Message Cause Action
Blank MD Blank discis in-
serted.
Replacedisc.
TEMP The temperature
of thisunit is out-
side ofthe nor-
mal operating
range
Wait untilthe
units temperature
returns towithin
normal operating
limits.
ERROR-11, 12,
17, 30
Dirty disc Clean disc.
ERROR-11, 12,
17, 30
Scratched disc Replacedisc.
ERROR-01, 11,
12, 17,30,A0,
A1
Electrical orme-
chanical
Turnthe ignition
ON andOFF,or
switch to adiffer-
ent source,then
back totheMD
player.
ERROR-20, 21 Trackinformation
cannot beread.
Reloadthe MD.
ERROR-20, 21,
24
There issome-
thing wrongwith
the MD.
Replacedisc.
ERROR-23 The MDcontains
recorded infor-
mation other
than music.
Replacedisc.
ERROR-A1 Electrical orme-
chanical
PressRESET.
ERROR- MD playnotpos-
sible.
Replacedisc, or
press RESET.
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
pears on the display refer to the table below to
see what the problem is and the suggested
method of correcting the problem. After
checking, try again.
Additional Information
En
65
English
Appendix