Filter
Top Products
1 Touch SPEAKER SETTING on the DSP
function menu.
2 Touch c or d to select the speaker to
be adjusted.
Each time you touch c or d selects the speak-
er in the following order:
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)—PHASE (subwoo-
fer setting)
# You can switch to PHASEonly when the sub-
woofer has been setto ON.
3 Touch c or d to select the correct size
for the selected speaker.
Each time you touch c or d selects the size in
the following order:
Speaker Setting
FRONT SMALL—LARGE
CENTER OFF—SMALL—LARGE
REAR OFF—SMALL—LARGE
SUB WOOFER ON—OFF
PHASE REVERSE—NORMAL
Correcting the subwoofer’s phase
If trying to boost the bass output of the sub-
woofer doesn’t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer’s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Touch SPEAKER SETTING on the DSP
function menu.
2 Touch c or d to select SUB WOOFER.
Each time you touch c or d selects the speak-
er in the following order:
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)—
SUB WOOFER (subwoofer)—PHASE (subwoo-
fer setting)
3 Touch c to turn subwoofer output on.
# To turnsubwoofer output off, touch d.
4 Touch d to select PHASE and then
touch c or d to select the phase of sub-
woofer output.
Touch d to select NORMAL (normal phase).
Touch c to select REVERSE (reverse phase).
Note
When playing a 2-channelmono source with Pro
Logic turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SMALLor LARGE and no center
speaker is installed.
! Audio is heard onlyover the center speaker if
installed and the centerspeaker setting is
SMALL or LARGE.
Adjusting the speaker
output levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch SPEAKER LEVEL on the DSP func-
tion menu.
2 Touch c or d to select the speaker to
be adjusted.
Each time you touch c or d selects the speak-
er in the following order:
Digital Signal Processor
En
89
Section
19
Digital Signal Processor