Filter
Top Products
Listening to the radio
1
2
6
5
7
4
3
8
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1 Sourcename
Shows the selected source name.
2 Sourceicon
Shows which source has been selected.
3 Bandindicator
Shows which band the radio is tuned to, AM
or FM.
4 Presetnumber indicator
Shows which preset has been selected.
5 STEREOindicator
Appears when the selected frequency is
being broadcast in stereo.
6 LOCALindicator
Appears when local seek tuning is on.
7 Frequencyindicator
Shows the frequency to which the tuner is
tuned.
8 Presetlist display
Shows the preset list.
1 Touch the source icon and then touch
TUNER to select the tuner.
2 Touch the screen to display the touch
panel keys.
3 Touch BAND to select a band.
Touch BAND repeatedly until the desired band
is displayed, FM1, FM2, FM3 for FM or AM.
4 To select a preset channel, touch a pre-
set channel on the list or touch a or b
(P.CH).
The preset channel you selected is tuned in.
# Touching LISTswitches between the preset
channel list display andthe a/b (P.CH) display.
Either way, the channels that can beselected are
the same.
5 To perform manual tuning, briefly
touch c or d.
The frequencies move up or down step by
step.
# You can also perform manual tuning bymov-
ing the joystickon the remote control left orright.
6 To perform seek tuning, keep touching
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seektuning by briefly touching
either c or d.
# If you keep touching cor d you can skip sta-
tions. Seek tuning startsas soon as you release
the key.
# You can also perform seek tuning byholding
the joystick onthe remote control left or right.
Note
If you do not usethe touch panel keys within 30
seconds, they will behidden automatically.
Tuner
En
26
Section
06