Filter
Top Products
! MUSIC – The Musicmode suitable for
music playback
! MATRIX – The Matrixmode for when FM
radio reception is weak
! OFF – Turn DolbyPro LogicII off
! ADJUST – Adjustthe Music mode
# You can operate ADJUSTonly when MUSIC
has been selected.
Adjusting the Music mode
You can adjust the Music mode with the fol-
lowing three controls.
! Panorama (PANORAMA) extends the front
stereo image to include the surround
speakers for an exciting “wraparound” ef-
fect.
! Dimension (DIMENSION) allows you to
gradually adjust the sound field either to-
wards the front or the rear.
! Center Width Control (CENTER WIDTH) al-
lows center-channel sounds to be posi-
tioned between the center speaker and the
left/right speakers. It improves the left-cen-
ter-right stage presentation for both the dri-
ver and the front passenger.
1 Touch DOLBY PRO LOGIC II on the DSP
function menu.
2 Touch MUSIC and then touch ADJUST.
# You can operate ADJUSTonly when MUSIC
has been selected.
3 Touch a or b to select PANORAMA (pa-
norama).
Each time you touch a or b selects the item
in the following order:
PANORAMA (panorama)—DIMENSION (di-
mension)—CENTER WIDTH (center width)
4 Touch c to turn the panorama control
on.
# To turnthe panorama control off, touch d.
5 Touch b to select DIMENSION and then
touch c or d to adjust front/surround
speaker balance.
Each time you touch c or d it moves the
sound towards the front or the surrounds.
+3 to –3 is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
6 Touch b to select CENTER WIDTH and
then touch c or d to adjust the center
image.
Each time you touch c or d it gradually
spreads the center channel sound into the
front left and right speakers over a range 0 to
7.
3 is the default and it’s recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to LARGE (large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select SMALL (small).
! When DIGITAL DIRECT is on, you cannot
select SPEAKER SETTING. First turn the
DIGITAL DIRECT off, referring to Using the
direct control on the previous page.
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SMALL or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
Digital Signal Processor
En
88
Section
19